Floriani No Show Nylon Mesh Fusible White
Floriani No Show Nylon Mesh Fusible is a sheer cutaway available in black, white and beige. By fusing the stabiliser to the back of the garment, you are more successful in hooping and do not stretch the garment out of shape.
The front of this baby’s fleece above looks natural and the handle of the fabric is very soft. Look how perfectly the outline follows the edges of the embroidery for perfect registration.
Unlike traditional cutaway, the beige mesh will not shadow through on light colored fabrics such as t-shirts/polo shirts etc. Its softness makes it particularly suitable for children's clothing and baby garments. After fusing (ironing), the backing is temporarily attached to the entire area where the embroidery will be stitched unlike spray adhesives which only "spot" tack and allow shifting of the fabric.
Other useful ways to use:
Above: Create beautiful soft applique edges with the point-turn method.
How to use Floriani No show Nylon Mesh Fusible:
Cut a piece of the stabiliser at least one inch larger than the hoop size you are planning to use.
Fuse the entire piece of the stabiliser on to the back of the garment using a low to medium temp, dry iron. (260°F, silk setting). When pressing the stabiliser on to the garment, the iron surface should touch the fabric, not the stabiliser.
Hoop the garment/fabric and place the embroidery frame on to the machine.
Important! If the design is denser than 6,000 stitches or if it is a poorly digitised design (too many stitches for designs size), "float" one layer of Floriani Medium Tearaway between the hoop and the bed of the machine for each additional 8,000 stitches for added support! After the design is complete the tear away can be removed leaving just the soft mesh against the skin.
After the design is complete, remove the garment from the machine and embroidery hoop. To remove the No Show Mesh Fusible, re-heat the stabiliser and peel it back gently to the design and trim.
*Tip! If embroidering knit, don't forget to use topping!
*Tip! To get extra support on large or problem designs without adding bulk, try crossing two layers of the fusible mesh, one at 90°and the other at 45°. This will offer a tremendous amount of stabilisation without stiffness.
Available in these sizes:
12in x 10 yds White, black and beige
20in x 10 yds - Ideal for large frames white and beige