Floriani Cutaway Medium Fusible 15in x 10yds by Floriani

Code FCMF1510
Floriani Cutaway Medium Fusible 15in x 10yds packetClick the image to enlarge
Code FCMF1510
Earn 0 reward points with this product.

Sorry we're out of stock!

Enter your email address below and we’ll notify you as soon as it becomes available.

  • Description

    Cutaway Medium Fusible 2oz, 15in x 10yds (38.1cm x 9.14M)

    Floriani Cutaway Fusible is a very soft yet solid 2.0 oz stabiliser that will support medium to heavy stitch count designs. It is ideal for fabrics that are considered un-stable; fabrics such as fleece, t-shirts, sweatshirts, polo knit, etc. Floriani Medium Cutaway Fusible stabiliser has a light fusible coating and is ideal for knits that tend to distort or stretch when they are hooped and/or when the embroidery is forming. The uniqueness of this product is the fact that it is fusible. This eliminates the need for messy spray adhesives which leave a residue on the needle, machine and fabric. By fusing the stabiliser to the back of the garment, embroiderer's are more successful in hooping and do not stretch the garment out of shape. Most importantly, the stabiliser is attached to the entire area where the embroidery will be stitched unlike spray adhesives which only "spot" tack and allow shifting of the fabric.

    To use Floriani Medium Cutaway:

    1. Cut a piece of the stabiliser at least one inch larger than the hoop size you are planning to use.
    2. Place the stabiliser to the wrong side of the fabric and hoop. Note! If using the fusible version, use a low to medium temp, dry iron (260°F, silk setting) to adhere to stabiliser to the back side of the fabric. The surface of the iron should touch the fabric not the stabiliser. Use a pressing cloth if necessary.
    3. Place the embroidery frame on the machine and complete the design. Note! If the design is denser than 14,000 stitches or if it is a poorly digitized design (too many stitches for the designs size), float an additional layer of Floriani Medium Tearaway between the hoop and the bed of the machine for each additional 10,000 stitches for added support.
    4. Once the design is complete, remove the hoop and garment from the machine and trim the stabiliser close to the design. If you have fused the stabiliser to the garment, apply heat and then pull it to the designs edge before trimming.

  • Reviews (0)

    Be the first to review this product.

    Leave your own review